The US tire special protection measures for China will expire on September 26 this year. Once again faced with this large export market in the United States, many tire companies in China are already eager to try. Although affected to a certain extent by the 2009 â€œtire special protection caseâ€, there is still no other country that can instigate the U.S. position as the first market for Chinese tire exports. The data for the whole year of 2011 and the end of 2012 to the end of May shows that the United States is the largest exporter of Chinese tires, whether it is car-car tires or car tires.
As far as the total exports of Chinese car tyres are concerned, in 2011, a total of 1.42 million tons of passenger car tyres were exported, an increase of 6.8% over the previous year. Affected by the special safeguard case, the number of exports to the United States continued to fall by 17.7% (a decrease of 19% in 2010), and the total annual export volume totaled 290,400 tons. From January to May of 2012, the total export volume increased by 10% year-on-year, and the number of exports to the United States finally stopped falling, which was an increase of 12.3% year-on-year.
According to relevant personage analysis, this aspect shows that the U.S. economy is recovering. On the other hand, the impact of the tire special protection case is gradually weakening.
In terms of truck and car tires, in 2011, China exported a total of 2.06 million tons, an increase of 12% over the previous year, and exports to the United States amounted to 378,300 tons, an increase of 12.8% over the previous year. From January to May of 2012, the export of truck and car tires increased by 20.4% year-on-year, and the number of exports to the United States was 169,000 tons.
In September this year, the tire special security case is about to expire. This is a good news for Chinese tire companies. In response, the responsible persons of a number of tire companies stated that they expect that total exports and net profits will increase in the second half of the year.
However, some people reminded that Chinese tire companies must establish â€œcrisis awarenessâ€. If they donâ€™t adjust their industrial structure when they are untimely, turning â€œbrilliant profits and quick salesâ€ into â€œexcellent quality and value for moneyâ€ will inevitably lead to similar dilemmas.
After the special safeguard case, the turmoil has not completely subsided, and Colombiaâ€™s anti-dumping investigations have begun again. It is reported that on June 22 this year, Colombia launched an anti-dumping investigation against Chinese tires. According to statistics, during the whole year of 2011, China exported 30,000 tons of tires to Colombia. In the first five months of 2012, China exported a total of 16,680 tons of tires to Colombia.
Although compared to the United States, the Colombian market appears to be â€œinsignificantâ€, but this policy will also have a certain impact on some tire companies. Some people believe that Chinese companies still lack the "law" to actively avoid anti-dumping.
It is understood that China's tire industry has accumulated anti-dumping investigations in a dozen countries including India, Argentina, Egypt, Brazil and Turkey. It has never been seen that China, as a large emerging trading nation, has increasingly expanded its economic and trade contacts with other countries in the world. Under fierce market competition, there are more and more opportunities for trade frictions and disputes.
In this regard, relevant experts said: â€œThe fundamental reason for anti-dumping is that Chinaâ€™s labor force is relatively â€œcheapâ€, and many workers are carrying out heavy work with meager wages, and the natural cost of the products produced is low. In the eyes of the country, it seems that it is damaging the rights and interests of its local industries. From the current point of view, adjusting the industrial structure, optimizing product quality, and increasing product prices are more feasible ways to avoid anti-dumping.â€
Grain cleaning machine Gravity Stone Remover
after raw material cleaning in grain processing plants, to grading grain, concentrate to clean impurities, (such as blighted wheat, small corn cobs, etc.) and to remove sand, mud. It use wind, vibrating and sieving effect matching technology, to be high efficiency, great performance on grading and separating gravel, mud pieces, low power consumption, no dust leakage, low noise, easy operation and maintenance.
1. Advanced design and excellent fabricating
2. Reliable and excellent stone separation and efficient cleaning
3.High specific capacity
4. Easy operation and maintenance
5. Two options: with or without air-recycling system.
6. A fan is equipped on the air-recycling type and a special separator is installed ahead of the fan. The separator deflects the aspirated air through a lamellar system so that dust and chaff are separated from the air and dischar
ged by an airlock valve while the cleaned air is recycled by the fan in the air return pipe to the destoner
1.The machine is designed for separating stones from a continuous product stream
2.On the basis of differences in specific gravity, reliable removal of highdensity impurities such as stones and pieces of metal and glass is achieved.
3. Versatile application in flour mills, rice mills, feed mils and seeds selection processing.
1.The sieve box which is normally equipped with two layer sieves is supported by hollow rubber springs and is caused to oscillate by one or twovibrators depending on machine execution.
2.The grain is spread by a feeder across the entire width of the machine, and then the product stream is stratified on the pre separation screen according to its specific gravity by the oscillating motion of the screen and by the air flowing through the product from bottom to top. The light particles collect at the top, and the heavy ones including the stones at the bottom.
3.The lower layer with the heavy particles flows upward and is fed to the final separation zone of the bottom de-stoning screen. Final separation of the stones from the grain is accomplished by a countercurrent of air.
4. The stone free product streams on the two screens float on cushions of air, flowing slowly toward the product outlet, and then are discharged through the squeezed rubber valves.
5. To achieve the optimum degree of separation, the inclination of the screens, the air volume and final separation can be adjusted accordingly.
The process of flour milling:
The process of flour milling (from corn to milled into corn flour) usually consists of the following:
1. corn storage (silos, or warehouse)
2. cleaning system (sifter, destoner, seprater, magnet, scourer, etc)
3. dampening (dampener, conditioning silos, etc)
4. milling system (roller mill, plansifter, purifier, impact detacher, etc.)
5. Flour pressure and blending system (if need)
6. flour packing and stacking
DingZhou YongSheng Grain and Oil Machinery Co., LTD is a professional company combining research and development design, production and sales as a whole. The company has first-class oil equipment manufacturing base, professional oil technology engineer and professor, possesses advanced production technology and sophisticated equipment, All the mechanical parts are manufactured by our company.
The complete sets of oil equipment that we manufactured, relying on many domestic scientific research institutions. Advanced technology, suitable for making all kinds of plant oil. From the raw material of cleaning up, prepressing, leaching, refining and the production processing of by-product (such as Phospholipids engineering, protein engineering), is totally a dragon design and production, has created considerable economic benefit and social benefit for the user and society more than 40 years. Company new development of biodiesel equipment technology in recent years, has put dozens of sets on the market, obtaining good economical benefits both In the domestic and overseas. At present, we have hundreds of successful installation operation of the oil equipment engineering experience, can design and product according to the difference of the user's economic condition. raw material. regional, install oil equipments.
YongSheng comapny with scientific management method, strives for perfection the manufacturing process, innovative manufacturing idea, fast grows and become the grain and oil machinery production and export base in China. Company products are exported to Russia, India, Nepal, Indonesia, South Africa,Tanzania,Ethiopia,Ukraine, kazakhstan, Pakistan, Iran, north Korea, Vietnam, France and the European Union and so on more than 30 countries and area.
Grain Destoner,Grain Stone Removing Machine,Seed Cleaning Machine,Grain Destoner Gravity Machine
Dingzhou Yongsheng Grain & Oil Machinery Co.,Ltd. , http://www.oilpresschina.com