Vortex Flowmeter Installation Tips

The vortex flowmeter can only measure one-way. When installing, pay attention to ensure that the direction of the medium flow is consistent with the direction indicated by the arrow of the flowmeter. 2. The vortex flowmeter 1 is installed vertically. The medium passes through the flow meter from bottom to top. The flowmeter is installed on a vertical pipe with the flow direction from bottom to top. 3. When installing horizontally, the flowmeter must be installed in the high pressure area of ​​the entire system and ensure the corresponding outlet pressure;
Do not install at the highest point of the pipeline, because the highest point is often gas accumulation, the pipeline is not full, the export can not be directly vented. 4. When measuring high temperature fluids, try to use vertical installation; if you have to install horizontally, please install the transmitter part of the flowmeter vertically or horizontally to avoid excessive temperature; pay attention to the air flow at the installation position Or well-ventilated. 5. Straight section requirements: at least 15 times the diameter of the flowmeter, and 5 times the diameter of the flowmeter. If the flowmeter is preceded by an interference source such as an elbow, indentation, or expansion, the diameter of the flowmeter must be 30-40 times the diameter of the flowmeter and 6 times the diameter of the flowmeter. The flowmeter should be installed upstream of the regulator valve, pressure or temperature sensor. 6. When installing, pay attention to the pipe diameter should be slightly greater than or equal to the inner diameter of the instrument. 7. When using the seal ring, pay attention to the inner diameter of the seal ring should be slightly greater than or equal to the inner diameter of the instrument, the center of the seal ring is located in the pipeline

Our company was set up in 2002.We are using the advanced cold punch technology to produce spark plug which is similar to NGK and Champion technology.With such technology, the metal shell and ceramic are better protected the quality of the spark plug are more stable to get avoid from air leaking and broken.Our spark plug products are ranged into more than 100 models with an anual out put of 6 million pcs. Besides the advanced technology,we also have a strong advantage of automatical production.Most of our production device is automatical that we have very high,efficiency and stable quality.Throughout such years of developing,we have gained a good reputation at domestic motorcycle manufacturer.Furthermore,our products have been exported to South East Asia, Middle East, Australia and so on. Revolution,refine and devotion are our principal of working.Welcome to visit us and raise your demand and your comments request are our target to strive.

Auto Double Iridium Spark Plug

Denso Spark Plug,Auto Iridium Spark Plug,Spark Plugs For A Car,Iridium Spark Plug For Car

LIXIN INDUSTRIAL & TRADE CO.,Limited , https://www.kgvsparkplug.com